Here is the logo that Michael has designed. I will make and inlay it into the headstock unless someone else would like to cut it out while I make the neck.
| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Where are we and whos got it? http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=7229 |
Page 1 of 1 |
| Author: | LanceK [ Wed Jun 21, 2006 10:16 pm ] |
| Post subject: | |
Where are we on this project? Does Brock have the box for binding? What about the neck? Where is it? Last I remember, John How was going to design an inlay and Michael Payne was going to do it? Yes? no? |
|
| Author: | Brock Poling [ Wed Jun 21, 2006 11:13 pm ] |
| Post subject: | |
I have it. I did a little scraping last night. It is almost done. |
|
| Author: | LanceK [ Wed Jun 21, 2006 11:30 pm ] |
| Post subject: | |
How about the neck? Fretboard? What is next after you level the bindings? |
|
| Author: | John How [ Thu Jun 22, 2006 12:09 am ] |
| Post subject: | |
I am ready to make the neck as soon as I get the guitar and fingerboard. I even have a couple of neck blanks already glued up depending on what is needed. I have a black/maple/black or a black/bloodwood/black center blocks. Who has the fingerboard? Brock, you can ship to: John How Guitars 2395 Indian Rock Rd Cool, Ca. 95614 |
|
| Author: | Brock Poling [ Thu Jun 22, 2006 1:30 am ] |
| Post subject: | |
Ok, will do. :-) |
|
| Author: | Michael Dale Payne [ Thu Jun 22, 2006 3:54 am ] |
| Post subject: | |
John I have the OLF peghead inlay pattern drawn up I will send it to you later today |
|
| Author: | John How [ Thu Jun 22, 2006 6:49 am ] |
| Post subject: | |
Here is the logo that Michael has designed. I will make and inlay it into the headstock unless someone else would like to cut it out while I make the neck.
|
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|